You are here: Tools > AKD into KAS > Workbench User Guide > Analog Output (X8, X23)

Analog Output (X8)

Analog Outputs can be used to output converted analog values of digital measurements recorded in the drive. The standard drive offers one analog output on X8. A list of the pre-programmed functions is included in the WorkBench setup software.

Technical characteristics

Output voltage range referring to AGND: ±10 V
Resolution: 16 Bit and fully monotonic
Update rate: 4 kHz
Unadjusted offset: < 50 mV
Offset drift typ: 250 µV/°C
Gain or slope tolerance: +/- 3%
Nonlinearity: < 0.1% of full scale or 20 mV
Output impedance: 110 ohms
Specification complies with IEC"International Electrotechnical Commission" IEC is a not-for-profit, non-governmental international standards organization that prepares and publishes International Standards for all electrical, electronic and related technologies 61131-2 Table 11
-3 dB BandwidthIn computer networking, bandwidth often refers to a data rate measured in bits/s, for example, network throughput. The reason for the connection of data rate with the term bandwidth is that the limit to the data rate of a physical communication link is related to its bandwidth in hertz: >8 kHz
Maximum output current: 20 mA
Capacitive load: any value but response speed limited by max Iout and by Rout
Protected for short circuit to AGND

Analog Output Wiring Diagram

Stay Connected with Kollmorgen

Open topic with navigation